Kitchen Cabinet Painting
Doors removed, degreased, sanded, primed and sprayed in a controlled booth. Boxes finished in place.
Kitchen Cabinet Painting - Canada
Don't replace your cabinets. Repaint them.
Endy Homes sprays your existing kitchen cabinets to a factory-grade finish in five days - for a fraction of the cost of new millwork, and with almost no mess.
- 5 days Average project time
- 70% Cheaper than new cabinets
- 5 yr Written finish warranty
The Colour Studio
Try a finish on a real kitchen
Tap a colour and watch it land on the cabinets above. These are our six most requested Canadian kitchen finishes.
Live 3D - move your mouse
What we do
Cabinet refinishing, done properly
Every job is sprayed on site with HVLP equipment, contained dust barriers and low-VOC coatings that are safe to live with.
Vanity & Bathroom Cabinets
Moisture-resistant coatings built for steam, splashes and daily wipe-downs.
Cabinet Door Replacement
Keep the boxes, swap the doors. New shaker or slab fronts, finished to match.
Colour Matching & Consultation
On-site colour consult with samples sprayed on your own door before you commit.
Hardware & Hinge Upgrades
Soft-close hinges, new pulls, drilled and aligned to a template so every handle lines up.
Millwork & Trim Spraying
Built-ins, wainscoting, doors and trim finished to the same standard as the kitchen.
How it works
Five days, start to finish
A clear sequence so you always know what is happening in your home.
Free estimate
We visit, measure, check the substrate and send a fixed written quote within 48 hours.
Prep & protection
Doors labelled and removed, floors and counters masked, dust containment installed.
Degrease, sand, prime
Kitchen grease is the number one cause of peeling. We degrease, scuff sand and bond-prime every surface.
Spray finish
Two to three coats of conversion-grade coating, sprayed for a smooth factory look with no brush marks.
Reinstall & walkthrough
Hardware fitted, doors rehung and aligned, and a walkthrough before we hand the kitchen back.
The workflow
How a kitchen actually gets painted
Ten stages, in order. Skip any one of them and the finish fails within a year - this is the part that separates a spray job from a paint job.
-
01
Inspection & adhesion test
We check the substrate - thermofoil, melamine, oak, maple or MDF all behave differently - and spray a test patch to confirm the coating will bond.
-
02
Doors, drawers & hardware off
Every door and drawer front is numbered and its hinges bagged, so each one goes back on the exact opening it came from.
-
03
Containment & masking
Plastic dust walls, floor protection, counters and appliances masked, and a negative-air fan so sanding dust never reaches the rest of the house.
-
04
Degrease, twice
Kitchen grease is the number one cause of peeling. Every surface is washed with a degreaser, rinsed, and wiped again before a single grit touches it.
-
05
Sanding & scuffing
All faces scuff-sanded to break the factory sheen and give the primer a mechanical key. Profiles and corners are done by hand, flats by orbital sander.
-
06
Fill, caulk & repair
Dents, chips, old hardware holes and open joints are filled, then sanded flush. Loose panels are re-glued and end panels re-caulked.
-
07
Bonding primer, sprayed
A high-adhesion bonding primer is sprayed - not brushed - so the film is even. This is the coat that decides whether the finish lasts five years or five months.
-
08
Sand between coats
The primer is sanded back with fine grit and vacuumed, then tack-clothed. This is what gives the final coat that glass-smooth feel.
-
09
Two to three topcoats
Cabinet-grade, low-VOC lacquer sprayed with HVLP equipment. Doors are finished flat in a controlled booth, boxes are sprayed in place.
-
10
Cure, reinstall & align
The coating cures hard before anything is touched. Then hinges, soft-close dampers and handles go back on and every door is aligned by hand.
Total on-site time: 4-5 days for an average kitchen.
Our works
Real kitchens. Drag to see the difference.
Same cabinet boxes, same layout - a completely different kitchen. Slide each photo to compare.
After
Before
After
Before
After
Before
After
Before
After
Before
After
Before
Why Endy Homes
The details that make a finish last
01
Sprayed, never rolled
HVLP spray equipment gives a level, factory-smooth surface with no stipple or brush lines.
02
Low-VOC, family safe
Water-borne coatings that cure hard but keep your home liveable while we work.
03
Fully insured crew
Liability insurance and WSIB coverage on every job across Canada.
04
5-year written warranty
If the finish chips, peels or yellows from a workmanship fault, we come back and fix it.
Reviews
What homeowners say
They finished in four days and the kitchen looks like it came out of a showroom. Not a single drop of paint anywhere it should not be.
Priya S.
We were quoted a huge amount for new cabinets. Endy Homes did it for a fraction and honestly I cannot tell the difference.
Daniel R.
The colour consult was worth it on its own. They sprayed three samples on our own door before we picked.
Megan T.
Clean, on time, polite crew. Two years on and the finish still looks the day it was sprayed.
Jean-Luc M.
Free estimate
Request a Free Quote
Send us a few details and a photo if you have one. We reply with a fixed written quote within 48 hours.
Prefer to talk it through?
Call or email and we will book an in-home estimate at a time that suits you. No pressure, no obligation.